-Aluminum Oxide grain-Resin on resin bond-Butt-tape joint for bi-directional sanding-X-weight cloth backing-Unique open/closed coat design

The 444 7 rafters square has a right angle guide and allows precision angle cuts.The roof rafter layout can also be used for for stair stringer layout.

Grip 50126 is a 3/8 Electric Reversible Angle Drill. This handy angle drill features a unique, ergonomic design, with a 55 degrees angled chuck for easy access to confined working areas. It has comfortable grip with efficient paddle switch.

The Alltrade 835702 is a 42 Stripping Bar with Claw. The medium-sized bar with nail-puller is for stripping and demolition work. It has forged, heat-treated carbon steel construction with corrosion-resistant gray finish.

Hitachis H45MRY Demolition Hammer with UVP (User Vibration Protection) is the first in its class with a dedicated anti-vibration mechanism. This UVP system combines counterweights and dampers to reduce vibration by over 50% and increase tool life by 30%. The H45MRY has an Impact Energy rating of 9.4 Ft-Lbs. The combination of less vibration, well-designed comfort features, and optimized striking performance adds up to unmatched productivity from the H45MRY.

The Milwaukee 49-56-9000 is a 2-1/8 Inch Big Hawg

Hobart Welders Weld-It H222108-R22 is a Flux-Cored Welding Wire. Great in single- or multi-pass welds particularly on thin-gauge mild or galvanized steel. Typically used for light structural, machinery part fabrication, prefab construction, railroad car repair, short assembly welds, tanks and general fabrication.

The Mercer 620140 is a 7 x 1/4 x 7/8 Depressed Center Metal Grinding Wheel. The metal grinding wheel is used for grinding all ferrous metals, steel, structural steel, rebar, bar stock, pipe and welds. The grinding wheel has an aluminum oxide grain which increases the life of the wheel. The wheel is also internally reinforced with layers of high tensile strength fiberglass and has a dual grit blend.

Denray 3696SS is a Down Draft Table with Push Button Cleaning. This table has a very unique feature that all of the inlet air enters the table through a long slot on each side. One side may be closed, which doubles the suction on the open side, it is a great feature when routing or with the removal of large amounts of dust. A highlight of this unit is the chip deflector, which is mounted on hinges and held in the upright position by two magnets. As a piece is being routed, the router chips hit the deflector, then are sucked down into the machine. The deflector can quickly be swung up into position or down out of the way. This is great for house doors, table tops, counter tops, etc. The counter sink bowls can be positioned inside the machine, allowing unlimited access to the counter tops edges.

Hobart Welders Weld-It H522506-R19 ER308L is a Stainless Steel Welding Wire. H522506-R19 is great in single or multi-pass welds particularly on thin-gauge mild or galvanized steel. An extra low carbon wire for the welding of type 304L, 321 and 347 stainless steels. It provides excellent notch toughness at very low temperature, and deposits a maximum of .04% carbon in the weld metal to minimize the formation of chromium carbides and consequent susceptability to intergranular corrosion. Typically used for light structural, machinery part fabrication, prefab construction, railroad car repair, short assembly welds, tanks and general fabrication.